DOUBLE WALL WATER COOLED HORIZONTAL LOAD VESSEL. INTERIOR HAS A MOLYBDENUM LINER WITH GRAPHITE HEATING ELEMENTS ON BOTH WALLS, ROOF AND FLOOR. 20 HP COOLING FAN MOUNTED IN REAR. PUMPING SYSTEM CONSISTS OF A STOKES 412-11 MECHANICAL PUMP WITH ROOTS BOOSTER. POWER TO THE HEATING ELEMENTS IS THROUGH VRT’S. A BATTERY POWERED LOADER IS INCLUDED. [...
Read More
SINGLE SIDE SWING DOORS WITH PRESSURE TYPE LATCHES. HEATING ELEMENTS AND THE BELT DRIVEN CIRCULATING FAN ARE MOUNTED ABOVE THE WORK CHAMBER IN A SEPARATE AREA. HEATED AIR IS CIRCULATED HORIZONTALLY IN THE WORK CHAMBER. AN AIRFLOW SWITCH MONITORS THE CIRCULATED AIR AND WILL TERMINATE POWER TO THE HEATING ELEMENTS IN THE EVENT OF FAN […]
Read MoreDOUBLE DOOR OPENING WITH PRESSURE TYPE LATCHES. HEAT IS SUPPLIED BY POWER FLAME 400,000 BTU BURNER FIRING INTO A PROTECTED CHAMBER IN THE REAR OF THE OVEN. HEATED AIR IS CIRCULATED HORIZONTALLY FRONT TO BACK BY A 3400 CFM FAN DRIVEN BY A 3 H.P. MOTOR. OVEN IS EQUIPPED WITH A 600 CFM POWERED EXHAUSTER. […]
Read MoreDOUBLE DOOR OPENING WITH PRESSURE TYPE LATCHES. HEAT IS SUPPLIED BY POWERFLAME 400,000 BTU BURNER FIRING INTO A PROTECTED CHAMBER IN THE REAR OF THE OVEN. HEATED AIR IS CIRCULATED HORIZONTALLY FRONT TO BACK BY A 7000 CFM FAN DRIVEN BY A 2 H.P. MOTOR. OVEN IS EQUIPPED WITH A 600 CFM POWERED EXHAUSTER. OVEN […]
Read More
OUBLE DOOR OPENING WITH PRESSURE TYPE LATCHES. HEAT IS SUPPLIED BY TUBULAR TYPE HEATING ELEMENTS. HEATED AIR IS CIRCULATED HORIZONTALLY BY (3) 2400 CFM FANS WITH DIRECT DRIVE TEFC MOTORS. ALUMINIZED STEEL INTERIOR WITH PAINTED STEEL EXTERIOR
Read More
ALL FURNACE SPARE PARTS, BELTS, BASKETS, TUBES , FANS, TRAYS ETC. ON SALE NOW…..
Read More
VARIABLE SPEED MESH BELT WITH CHAIN EDGE DRIVE. TWO ZONE GAS FIRED (1 MILLION BTU/HR. MAX. TOTAL) WITH (2) PACKAGE BURNERS FIRING INTO REMOVABLE ROOF MOUNTED COMBUSTION CHAMBERS. PARTS TO BE HEATED ARE LOADED AT THE 5′ OPEN BELT LOADING, PASS THOUGH 40′ LONG HEATED AREA AND ARE UNLOADED AT THE 3′ LONG EXIT. AIR […]
Read More
THIS IS A GLOBAR HEATED, FULL MUFFLE ATMOSPHERE FURNACE . PARTS ARE LOADED ON TO A 12″ WIDE MESH BELT. PARTS PASS THOUGH A 12′ LONG HEAT SECTION AND THEN PASS THOUGH 26′ OF WATER JACKETED COOLING. PARTS ARE THEN UNLOADED ON A 2.5′ LONG UNLOAD TABLE. GLOBAR HEATING ELEMENTS ARE LOCATED ABOVE AND BELOW […]
Read More